Emergency Response PlanAll Emergencies should be reported to 911 EMERGENCY TYPE The following situations are considered emergency response actions and should be handled in accordance with the procedures outlined in this plan.
- Serious Injury/Fatalities
- Structural Damage/Collapse
- Weather or Geological Event
- Environmental Incident
- Utility Damage
- Illegal Activity
- Labor Problems
- Bomb Threats/Military Ordinance Unearthing/Acts of Terrorism
Emergency Contact Names and Numbers
First call: 911 Fire or Police2nd Call: Consigli Project Superintendent: John Leofanti (508)958-6969 3rd Call: Consigli Project Manager: Greg O’Donnell (774)278-0482 4th Call: Consigli Project Engineer: Abigail Crothers (774)573-3184 5th Call: Consigli Safety Director: Dan Della-Giustina (508)686-6008
ADDITIONAL PROJECT CONTACT NUMBERS
|General Superintendent: Mike Caputo – (774)573-4082 Project Executive: Mark Morrow – (508)922-7352 Safety Manager – Eddy Pellerin – (508)962-3974|
Umass General Hospital
(617)726-2000Back– End of Medical Facilities
Site Safety PlanScope of Proposed Operations:
**Review Chapter 4 for more detail**
**Review Chapter 13 for more detail**Work on Ladders: All work on step ladders/straight ladders will be done correctly per manufacturer’s recommendations. Any worker who is on a step/straight ladder and could be exposed to a fall greater than the height of their work on the ladder will be required to tie off. Only ladders with a rating Type 1A or 1AA will be allowed on Consigli projects.
**Review Chapter 4 for more detail**Scaffold and elevated work platforms: When used, scaffolds will be inspected daily before each shift by a competent person designated by each contractor using it. The inspections will be documented on the Consigli inspection checklist.
** Please review chapter 14 for additional details. **Aerial/Scissor Lifts: Area and ground conditions in the intended work area will be inspected for overhead power lines, sink holes, covers, or any other unsafe condition which causes the potential for an incident. Aerial and scissor lift platforms will be inspected daily before each shift by a competent person designated by each individual contractor who will be using it. All contractors who will be performing work from an aerial lift will show documented proof of training for all workers who will be using said lift. Workers will be tied off at all times when using an aerial lift.
**Review chapter 24 for more detail**Chemical and Materials: All Materials and chemicals used on-site will have a Safety Data Sheet (SDS) provided before being brought onsite.
- SDS sheets on file in Consigli Construction’s Site Safety Plan
- All SDS sheets shall be readily accessible.
** Please review chapter 20 for additional details. **Fire Protection: A detailed NFPA 241 plan will be created for the project and updated as required. All hot work to be conducted on this project will be done with the Consigli hot work permit program fully implemented. This will be coordinated through Consigli as well as the local Fire Department (if required).
**Review Chapter 17 for more detail.**Electrical: All electrical tools, cords and equipment must be in good working order. To that end, all electrical tools and components must be visually checked on a daily basis. Any tools with damaged cords or damaged cords must be taken out service immediately. If necessary, lock-out/tag-out procedures will be reviewed with the building facilities staff regarding control of the keys and shut-down requests. All temporary power for the project will be installed on protected and dedicated circuits with 100% GFCI protection. No live electrical work will be conducted per NFPA 70E.
**Review Chapter 26 for more detail**Utility Exposures/Excavations: Utility locations shall be determined by Dig-Safe and private survey as well as any “as-built” drawings prior to any excavation work conducted on the property. If an excavation nears identified utility lines, hand digging methods must be used to find the exact location of the utility in question. Designated First Aid Plan: Consigli Construction shall follow Site Safety Plan for first Aid. Report any incidents to the Safety Director.
** Please review chapter 1 and 27 for additional details. **Evacuation Plan (RACE, and Routes of Egress): Please refer to the Evacuation Plans attached. All contractors’ employees shall attend the Consigli Construction Project Orientation. Consigli Construction’s Project Superintendent shall conduct safety orientation training with each employee and project subcontractors. Training will involve site specific safety and evacuation protocol. Emergency Management Response: In the event of an Emergency the construction workers shall leave the building immediately. Point of assembly/muster shall be on the site evacuation plan. In the Event of a DISASTER, the Superintendent shall instruct the construction workers to leave the site or remain in place and await further instruction. The following steps should be taken in the event of an emergency When reporting an emergency, please provide the following:
- Nature and extent of the incident (injury, accident, spill, smoke/fire, damage, etc.);
- The name and amount of the material spilled (if applicable); and
- The safest route to the spill (if applicable).
**Review Chapter 4 for more details**Back– End of Site Safety Plan
Environmental Emergency Contact and Management ResponseIAQ (indoor air quality): If this project will occur in an occupied building, a baseline survey of the air quality will be completed. Dust control, housekeeping, and frequent monitoring will ensure no impact on the air quality for the existing building occupants.
** Please review chapter 29 for additional details **Asbestos: IT IS THE RESPONSIBILITY OF ALL SUBCONTRACTOR FOREMEN TO REVIEW THE HAZARDOUS MATERIAL REPORT & CORRESPONDING
Name: Cyn Environmental Services, Inc.
** Please review chapter 29 for additional details **Silica: Any activity which can produce silica dust will use engineering controls to keep dust to a minimum. A written exposure plan must be developed for all silica producing tasks. Polychlorinated Biphenyl’s (PCBs): Light ballast unless labeled “No PCB’S” will be designated PCB containing, All PCB containing material shall be removed and disposed of in accordance with all local, state (MEMEP Special waste management rules 06-096-CMR 400) and federal regulations and be coordinated with BIDMC. All other inquiries or locations in regards to PCB containing material can be located in the Hazardous Material survey. If identified on any of the materials to be impacted, PCB‘s will be abated. Any and all PCB remediation will be performed by a licensed /qualified contractor Mold: If mold is discovered, Consigli’s mold remediation policy will be implemented and followed.
** Please review chapter 22 for additional details **Noise: Noise exposure will also be a concern so all deliveries must be coordinated with the Superintendent to limit their impact on the surrounding areas. Normal working hours will be between 7:00 am and 3:30 pm Mon-Fri. Any contractor who may need to work late must first seek approval from the Superintendent. Consigli permissible noise policy and procedures will be followed.
** Please review chapter 29 for additional details **Heavy Equipment: All operators will be required to have in their possession all appropriate licensing and training as required by OSHA and the Commonwealth of MA.
** Please review chapter 24 for additional details **Adjacent Property: All efforts will be made to ensure that property and roadways adjacent to the work, area remains un-impacted. It is anticipated that all work will be in the designated work areas within the site fence. Any deviation from that will require consultation with the Superintendent. Exposure to Street Traffic: All speed limits will be obeyed, and deliveries will be made as to coincide with working hours. All traffic control signage will meet MUTCD requirements before being installed. Fire dept. access will be maintained and kept open for emergency responders. Site Orientation: All individuals working on this project will receive a comprehensive Safety Orientation which will cover all company safety rules regulations and procedures as well as communicating Consigli specific requirements. Back– End of Environmental Emergency Contact and Managemen Response